By Vic Tagawa, November 2019
Part numbers for Borg stems.
If your Sprinter has Steel inner dual wheels & Steel outer dual wheels with Oval holes 3.5″ x 1.75″ in the outer wheel your kit is the DL1SP16
If your Sprinter has Steel inner dual wheels & Steel outer dual wheels with Oval/ Round alternating holes oval size is 3″ x 1.25″ in the outer wheel your kit is the DL1SP
If your Sprinter has Steel inner dual wheels & Steel outer dual wheels with Round 1.5″ holes in the outer wheel your kit is the DL1SP13
If your Sprinter has Steel inner wheels & Aluminum Alcoa outer dual wheels with rounded rectangle holes 3.5″ x 1.5″ in the outer wheel your kit is DL1SPAL
If your Sprinter has Steel inner wheels & Aluminum NON-ALCOA outer dual wheels with Hexagonal shaped holes in the outer wheel your kit is DL2SPNA
If your Sprinter has Aluminum ALCOA inner wheels & Aluminum ALCOA outer dual wheels rounded rectangle holes 3.5″ x 1.5″ in the outer wheel your kit is DL1SPAA
I have the Stylized Aluminum wheels and installed the DL2SPNA on my 16V. I don’t think a DL3SPNA was available at that time.
For the fronts this is what they sent:
VHVS8175 1.75″
VHVS8075 0.75″ (recommended of using External TPMS)
I tried the longer ones, but didnt like the TPMS sensor resting on the wheel, so I went with the 3/4″ that they recommended, much better fit and air flow.
Wheel | Hole | Kit |
Steel Inner & Outer Dual | Rounded rectangle holes 3.5″ x 1.5″ | DL1SP13 |
Steel Inner & Outer Dual | Oval/ Round alternating holes oval size is 3″ x 1.25 | DL1SP |
Steel Inner & Outer Dual | Round 1.5″ holes in the outer wheel your kit is the | DL1SP13 |
Steel inner & Aluminum Alcoa outer | Rounded rectangle holes 3.5″ x 1.5″ | DL1SPAL |
Aluminum ALCOA inner & outer | Rounded rectangle holes 3.5″ x 1.5″ | DL1SPAA |
Steel Inner & Aluminum NON-ALCOA | Hexagonal shaped holes in the outer wheel | DL2SPNA |
Fronts | 1.75″ 0.75″ (recommended of using External TPMS) |
VHVS8175 VHVS8075 |
The Borg Stems need to be updated for the 2020+ Winnebago. The information shown in the table is not valid as the wheel has been changed. I bought parts based on this information and now I have $140.00 that I cannot return.
Did you call Kelly at Borg to order them? What style wheel do you have, that’s not on the list?
I have an 11K, my simulators twisted and rubbed against the valve stem which resulted in a groove that does not extend to the internal airway. Wheels still hold pressure just fine. My question is, can I buy just a few select stems to replace damaged parts without purchasing the entire kit?
Anyone have a problem with these leaking? I have one rear wheel that has developed a leak twice at the base of the stem. Installer is a Mercedes Sprinter shop.